4 sdec hardware connection, 1 audio connections, Figure 1 – JBL SDEC-4000 User Manual
Page 6
- 6 -
SDEC -X000 DACS Calibration Manual v1.0.doc
4 SDEC Hardware Connection
Please refer to the SDEC Installers Manual for detailed hardware connection instructions and diagrams. Check the SDEC for correct
connection using the below chart for SDEC-3000 and the next page for SDEC-4000 installations:
•
Make sure you have access to the SDEC-3000 or SDEC-4000P and SDEC-4000X Ethernet port(s).
•
Make sure you are using the correct interconnect kit, S3000IC or S4000IC.
•
The system should pass audio and all channels should operate before beginning the calibration.
•
The SDEC-4000P and SDEC-4000X need to be connected to each other via the Cobranet
®
connection using a CAT5e crossover
network cable and must be a minimum of two feet (0.7 meter) long.
4.1 Audio Connections
SDEC-3000 7.1
Surround Processor to SDEC3000 Inputs
S3000IC
Number
Channel
SDEC3000
Inputs
1
Left Front
A1
2
Right Front
A2
3
Center Front
A3
4
Left Side
A4
5
Right Side
B1
6
Left Rear
B2
7
Right Rear
B3
8
Subwoofer
(Mono Sub LEFT)
B4
SDEC3000 Outputs to Amplifiers
S3000IC
Number
Channel
SDEC3000
Outputs
9
Left Front
C1
10
Right Front
C2
11
Center Front
C3
12
Left Side
C4
13
Right Side
D1
14
Left Rear
D2
15
Right Rear
D3
16
Subwoofer
D4
Figure 1.