John Deere AC-6000SB - Manual (Page 9)

Toolbox Installation Instructions 9
Installation
INSTALLATION INSTRUCTIONS (CONTINUED):
CAUTION: SAFETY GLASSES SHOULD BE WORN
DURING THIS STEP OF THE INSTALLATION.
4. Drill 3/16“ holes through the inside of the side mount
toolbox (A) (Fig. 4) and the pickup truck bed rail according
to the part number listed below:
• 91 - Drill four holes through the bed rail.
• 92 - Drill six holes through the bed rail.
• 93 - Drill eight holes through the bed rail.
Secure into position using 1/4 x 1“ sheet metal screws.
Tighten into place using a 3/8“ wrench / or socket.
NOTE: Do not overtighten the sheet metal screws. Make sure
that if your vehicle already has a crossover toolbox
installed, that you position your side mount toolbox so that
it is aligned with the crossover toolbox.
(Fig.4)
A