JVC HR-A231EK - Manual (Page 8)

8
INITIAL SETTINGS (cont.)
q 6
Clock Set
If you performed Auto Channel Set (
੬
pg. 7), the recorder’s
built-in clock is also set automatically. The Auto and Manual
clock setting procedures are necessary when . . .
– a power outage of more than 3 minutes occurs.
– the tuner has been set manually.
– the user desires to set the clock slightly ahead of the actual time.
– the clock was not set even after Auto Tuner Set was performed.
Whether you perform Auto or Manual clock setting, you can
use the convenient Just Clock function.
Just Clock
The Just Clock function provides accurate time keeping through
automatic adjustments at regular intervals, by reading data from
a PDC signal.
The Just Clock option appears in the Just Clock display, and can
be set “ON” or “OFF” (the default setting is “ON”). Press OK
until the Just Clock setting begins blinking, then press PUSH
JOG
%fi to change the setting.
IMPORTANT: If you turn off Just Clock off, the accuracy of your
recorder’s built-in clock may be reduced, which could
adversely effect timer recording.
Both Auto and Manual clock setting procedures begin from step 3.
1 2
4 5
3
6
8
0
7 9
1
3
2
OK
2,4
1
Just Clock Preset Position
≠
CONTINUED ON NEXT PAGE.
SET CLOCK
AUTOMATICALLY
3
At the Clock Set display, press PUSH JOG . The Clock
Set display blinks and clock setting begins.
● If the Just Clock preset position isn't set to the preset
position on which Auto Clock data is received,
"Err"(or) appears, and then the display from step 2
reappears. To set the Just Clock preset position, press
OK until the Just Clock preset position begins
blinking, then cycle through the numbers by pressing
PUSH JOG
%fi until the number representing the
preset position in which the station transmitting clock
setting data (BBC1, BBC2, etc.) is stored appears.
Auto Clock Set
Preparation
TURN THE RECORDER ON
1
Press OPERATE.
ACCESS CLOCK SET
DISPLAY
2
Press CLOCK on the remote control. The Clock Set
display appears.
OPERATE
1
CLOCK
OPERATE
%
PUSH JOG
3