JVC HR-A231EK - Manual (Page 13)

13
Index Search
Your recorder automatically marks index codes at the beginning
of each recording. This function gives you quick access to any
one of 9 index codes in either direction.
NOTE:
Before starting, make sure the recorder is in the Stop mode.
q 6
1 2
4 5
3
6
8
0
7 9
1
3
2
DISPLAY
ACTIVATE INDEX SEARCH
1
Press PUSH JOG or (™ or £). “–1” or “+1” is
displayed on the display panel and search begins in the
corresponding direction.
● To access index codes 2 through 9, press PUSH JOG
or repeatedly until the correct index number is
displayed.
Ex.: To locate the beginning of B from the current
position, press PUSH JOG twice.
To locate the beginning of D from the current
position, press PUSH JOG once.
● When the specified index code is located, playback
begins automatically.
Current position
Index number
% fi
% fi
fi
%
A B C D E F
–2 –1 1 2 3
Repeat Playback
Your video recorder can automatically play back the whole tape
20 times repeatedly.
START PLAYBACK
1
Press PLAY.
ACTIVATE REPEAT
PLAYBACK
2
Press PLAY and hold for over 5 seconds, then release.
● The Play indicator ( ) on the display panel blinks
slowly.
● The tape plays 20 times automatically, and then
stops.
STOP PLAYBACK
3
Press STOP at any time to stop playback.
NOTE:
Pressing PLAY, REW , FF or PAUSE also stops Repeat Playback.
PLAY
FF
PAUSE
REW
STOP
FF PLAY
REW
STOP
PAUSE
PUSH JOG