JVC HR-A231EK - Manual (Page 7)

7
1 2
4 5
3
6
8
0
7 9
1
3
2
Your recorder needs to memorise all necessary stations in preset
positions in order to record TV programmes. ATS+ (Auto Tuning
System) automatically assigns all receivable stations in your
area to call them up with the TV PROG. buttons without going
through any vacant channels.
The following procedure describes how to select automatic
channel setting.
q 6
INITIAL SETTINGS
Tuner Set
OPERATE
OK
TV PROG.
CH SET
2,5
1
3
TURN ON THE RECORDER
1
Press OPERATE.
ACCESS CH. SET DISPLAY
2
Press and hold CH SET for more than 2 seconds.
“AUTO” appears on the front display panel.
START AUTO CHANNEL SET
3
Press OK and “AUTO" blinks on the front display panel.
ACCESS CONFIRMATION
DISPLAY
4
The preset position, channel and station name (ID –
੬
pg. 30) of the stations located by your recorder appear
in a Confirmation display.
(Ex.)
Confirm all the stored stations by using PUSH JOG %fi.
RETURN TO NORMAL
DISPLAY
5
Press CH SET.
● Using the Confirmation display, you can skip or add
preset positions, enter station names and perform
other operations. Refer to page 26 for the procedures.
● Depending on the reception conditions, the stations
may not be stored in order, and the station names
may not be stored correctly.
OPERATE
1
TV PROG.
PUSH JOG fi%
4
Preset Position
≠
Station Name
≠
Channel
≠
NOTES:
● Fine tuning is performed automatically when you select
“AUTO CH SET”. If you want to perform it manually, refer to
page 29.
● To set the tuner manually, refer to “Storing Channels Manually”
(
੬
pg. 26).