JVC DT-V17L3DY - Manual (Page 16)

16 External Control
7 About the external control
This monitor has three external control terminals.
• MAKE/TRIGGER terminal (RJ-45): The following external control systems are available.
(1) MAKE (make contact) system: Controls the monitor by short-circuiting the corresponding pin terminal to
the GND pin terminal, or disconnecting (opening) it.
(2) TRIGGER (trigger) system: Controls the monitor by sending the pulse signal instantaneously to the
corresponding pin terminal.
☞ “Using the MAKE/TRIGGER system” on page 17
• RS-485 terminals (RJ-45): Controls the monitor with the RS-485 system. (
☞ “Using the serial communication”
on page 18)
• RS-232C terminal (D-sub 9-pin): Controls the monitor with the RS-232C system. ( ☞ “Using the serial
communication” on page 18)
Set the following items of “REMOTE SETTING” in SET-UP MENU according to the external control terminal and
control system (
☞ “SERIAL TYPE”, “PARALLEL TYPE” on page 15).
Control terminal Control system
The settings of this unit
“SERIAL TYPE” setting “PARALLEL TYPE” setting
MAKE/TRIGGER
terminal MAKE — MAKE
TRIGGER — TRIGGER
RS-485 terminal Serial
communication RS-485 RS485* 1 —
RS-232C terminal RS-232C RS232C* 1 —
* 1 For a monitor connected to a personal computer etc, select the terminal the equipment is actually connected to. For
other monitors, select “RS485.”
PC, etc.
RS-485 IN
or
RS-232C
RS-485
OUT
RS-485
IN
RS-485
OUT
RS-485
IN
RS-485
OUT
Control priority is as follows.
MAKE > TRIGGER = serial communication = buttons and menu on the monitor
• You can use the external control even when “CONTROL LOCK” is set to “ON” ( ☞ page 15).
• When the monitor is off (on standby), external control is not available. But certain external controls (starting/
terminating communication, turning on the monitor) are available through the serial communication ( ☞ page 18).
You can control the monitor by a personal computer or dedicated controller*
2 .
• For the details, see page 17.
* 2 The controller is not commercially available. Consult your dealer if you need it.
• For the details, see page 18.