Fast heat up" function, Demo mode, Beep" mode – John Lewis JLBIOS602 User Manual

Page 14

"Fast Heat Up" function

After a cooking function has been selected and the temperature has
been adjusted, the cavity will gradually heat up until the selected
temperature is reached. This will take from 10 to 15 minutes,
depending on selected function and temperature.
If it is necessary to reach the required temperature in a shorter time,
the "Fast Heat Up" Function can be used.
1) Switch the oven on by pressing button

2) Set the required cooking function and temperature as explained

in the previous pages.

3) Set the temperature by pressing button “

“ or “ “. The

temperature will appear on the display.

4) Press button Fast heat up . The temperature display will show

"FHU" (Fig. 18).

5) press button Oven function and the symbol “°°°°°” will flash for

approximately 10 seconds. Now it is possible to select the
required temperature by pressing button “ “ or “ “.

4) When the required temperature is reached, an acoustic alarm

will sound for a short time, and the temperature display will
revert to the set temperature.

This function can be used with any cooking function or temperature.

Demo mode

This mode is intended to be used in the shops to demonstrate
the oven functionality without any power consumption except
the oven lamp. To activate this function the appliance should be
in stand-by mode.

—

Press button Fast heat up and

“ “

for approximately 2

seconds (Fig. 19). An acoustic alarm will sound for a
short time.

—

Press button

and the “

” indication will appear in the

display.

All oven functions can be selected.

The thermometer symbol will flash as “

” indication and

number digits.
Follow the

Follow the

Follow the above described

above described

above described procedure to d

procedure to d

procedure to dis-

is-

able

able the demo mode.

the demo mode.

Errrrrror code

or code

The electronic programmer does a continuous diagnostic check
of the system. If some parameters are not correct, the control
unit will stop the activated functions and it will show on the
display the corresponding error code.
For further details, refer to chapter "Something not work-
ing“ on page 22.

Fig. 18

Fig. 19

"Beep" Mode

You can choose to make The Electronic Control beep each
time that a control is touched.
To enable this function, the oven must be off.
1.Press controls Oven functions and

“ “

at the same time

for about 3 seconds. The Electronic Control beeps once

To disable the "Beep" Function:

1.If the oven is on, press button

to switch it off.

2.Press controls Oven functions and

“ “

at the same time

for about 3 seconds. The Electronic Control beeps once