Jacuzzi Summer Rain 2 Wall and 3 Wall - Manual (Page 20)

STEP 7
With a large screwdriver and the tool included with the
drain, tighten the inside compression nut to seal the
drain pipe connection. After drain is fully installed, test
for proper drainage. If the shower base does not drain
properly, rectify this condition before proceeding with
the installation. Jacuzzi Whirlpool Bath is not respon-
sible for removal and/ or reinstallation costs.
NOTE: Watertight installation of the drain is the
installer’s responsibility. Drain leakage is excluded
from the Jacuzzi Whirlpool Bath warranty.
Replace the strainer and tape over the drain hole to
prevent finishing material from entering drain.
STEP 6
With the drain fitting passing over the center of the
drainpipe, lower the shower base carefully into place,
push down firmly until the base is in place. You must
check the level of the base in two directions. Do not lift
a corner to level the base. This will cause a loss of
contact with the mortar. Attach the shower base flange
to the stud wall and blocking with self-drilling screws
(included). Use a minimum of 3 screws per flange
section.
NOTE: If there is any gap between base flange and
stud or blocking, shims MUST be used to prevent
distortion or cracking of the flange.
STUD
CEMENT BOARD
1/4" MINIMUM GAP
SILICONE
SEALANT
TILE
TILE
ADHESIVE
1/4" MINIMUM
GAP
SILICONE
SEALANT
STUD
CEMENT
BOARD
1/8" GAP
GROUT
STUD
SHIM IF NECESSARY
DO NOT FILL
CEMENT
BOARD
TILE
SILICONE
SEALANT
1-1/8" MAXIMUM
NO MINIMUM
3 WALL BASE INSTALLATION
CLEAN-UP AFTER INSTALLATION
To avoid dulling and scratching the acrylic surface of
the base, never use abrasive cleaners. A mild liquid
detergent and warm water clean soiled surfaces.
Remove spilled plaster with a wood or plastic edge.
Metal tools scratch the surface. Spots left by plaster or
grout can be removed if lightly rubbed with detergent on
a damp cloth or sponge.
Paint, tar, or other difficult stains can be removed with
paint thinner, turpentine, or isopropyl alcohol (rubbing
alcohol).
Minor scratches which do not penetrate the color
finish can be removed by lightly sanding with 600-grit
wet/dry sandpaper. You can restore the glossy finish to
the acrylic surface of the base with a special compound,
Meguiar’s #10 Mirror Glaze. If not available, use auto-
motive rubbing compound followed by an application of
automotive paste wax.
Major scratches and gouges which penetrate the
acrylic surface require refinishing. Ask your Jacuzzi
Whirlpool Bath dealer for special instructions.
18