JVC TV-20F243 - Manual (Page 12)

10
BATTERY INSTALLATION
BATTERY PRECAUTIONS
NOTE: • When there is an obstacle between the TV/VCR and the transmitter, the transmitter may not operate.
• When direct sunlight, an incandescent lamp, fluorescent lamp or any other strong light shines on the
Remote sensor of the TV/VCR, the remote operation may be unstable.
The precautions below should be followed when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment.
Reversed batteries may cause damage to the device.
3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh
ones.
4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury
from possible battery leakage.
5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow
battery manufacturer’s directions.)
6. When you change the batteries, try to complete the task within three minutes. If you take longer than three
minutes, the remote control codes for your Cable Box may have to be reset (see page 11).
EFFECTIVE DISTANCE OF THE REMOTE CONTROL TRANSMITTER
REMOTE CONTROL
(CONTINUED)
Install two “AA” (penlight
size) batteries, paying
attention to the polarity
diagram in the battery compartment.
Slide the battery compart-
ment cover in the direction
of the arrow. Replace the compartment
cover. 1 2 3
15 FEET
30˚ 30˚
5B40401A-E/P10-19 15/01/2002, 12:54 10