JVC VN-S200U/S100U - Manual (Page 12)

12
Procedure
1. On the menu bar, select [View] - [Controller].
2. Among the currently displayed View windows, click the one where the
V.NETWORKS to be controlled is registered in order to make it active.
3. If more than one V.NETWORKS has been registered in the View window,
interrupt the image switching by clicking the [Pause Switching] button
on the controller.
4. Click the pull-down menu of the controller to select the V.NETWORKS to
be controlled.
CONTROLLING THE V.NETWORKS
This section describes how to pan, tilt or zoom the connected V.NETWORKS
using the controller and set it to the condition in which viewing is required.
When the connection destination is the VN-C1U : Pan/tilt/zoom/position memory operations are
not available.
When the connection destination is the VN-C2U : Zooming operation and position memories
7 to 10 are not available.
PAN/TILT buttons
Control the panning and tilting of
the selected V.NETWORKS.
View window name
Name of the controlled View window
Pause Switching
Lets the image switching
operation pause temporarily
V.NETWORKS name
Select the V.NETWORKS
to be controlled
PAN/TILT
Shows the current
pan/tilt position
LENS
Controls the zooming,
focusing and iris of the lens.
Position memory
Press one of the buttons to point to a preset position.