Remote control – JVC 1208TSH-II-IM User Manual

Page 18

The following pages gives you a brief description of each button’s function.
This remote can also control up to four other devices. See pages 51 - 52.

Remote Control

TIMER

Allows you to set the TV to turn on and set the TV to turn off
automatically after a set amount of time and channel of your choice.
On Timer / Input / Sleep Timer

Notes:
• If you set the interval of On Timer by pressing the

buttons,

select channel at Input and press OK.
• After you set On Timer and turn off the TV, power lamp lights.
• You can check the remaining time of On Timer by displaying
this menu again.
• You can set the interval of Sleep Timer by pressing the

buttons.

• 60 seconds before the TV turns off, a message will appear and it

will count the remaining time.

• See page 50, “On Timer using iPod”.

POWER

Turns the TV on or off.

MODE

STB

VCR

DVD AUDIO

Switch between “TV / STB / VCR / DVD / AUDIO devices.
See page 51.

Switch between devices connected to Video-1, 2, 3, 4 and 5. For
V4 (Video-4) and V5 (Video-5) you must select the signal input type
fi rst (ie. composite, S-Video, or component). To do so, you need
to press the V4 or V5 button until the correct type is highlighted.
Select “Composite 1” for composite video signal input, “S-Video”
for S-video signal input, or “Component 1” for component video
signal input. Select “Composite 2” for composite video signal input
or “Component 2” for component video signal input. Select PC for
PC signal input.

TUNE

RETURN +

Change channels. Input remote codes. See page 51.

TUNE

Lets you decide the input channel and select it. After pressing the
remote 0 - 9 buttons, press TUNE.

0 h 0 m

0 - 0

0 min

Timer

On Timer

Input

Sleep Timer

LCT2518-001A-A.indd 18

1/14/09 8:54:58 AM