JVC HR-J440U - Manual (Page 16)

16
EN
Simple
Recording
LOAD A CASSETTE
1
Make sure the record safety tab is intact. If not, cover the
hole with adhesive tape before inserting the cassette.
SELECT RECORDING
CHANNEL
2
Press CH 5∞. Or press the appropriate NUMBER keys,
then press ENTER. (The channel changes after a few
seconds whether you press ENTER or not.)
● If you use the RF connection, by pressing the TV/VCR
button, select VCR mode to view the program to be
recorded.
SET TAPE SPEED
3
Press SP/EP to set the recording speed.
START RECORDING
4
Press and hold REC and press PLAY on the remote
control, or press REC on the VCR's front panel.
PAUSE/RESUME
RECORDING
5
Press PAUSE. Press PLAY to resume recording.
● During record pause, you can change the recording
channel by using the CH 5∞ buttons or NUMBER keys.
STOP RECORDING
6
Press STOP or STOP/EJECT. Then press STOP/EJECT to
remove the cassette.
SIMPLE PLAYBACK AND RECORDING (cont.)
3
¶
4 ¢
7 8
1 ¡
1 2 3
4 5 6
7 8
0
9
2 2
q 5 / 8 6
PLAY
CH
STOP/EJECT
PAUSE
REC
CH
PAUSE
STOP
PLAY
SP/EP
REC
ENTER
Turn on the TV and select the VCR channel 3 or 4 (or AV
mode).
TV/VCR
● To prevent accidental recording on a recorded cassette,
remove its record safety tab.
To record on it later, cover the hole with adhesive tape.
Record safety tab
Accidental erasure prevention
NUMBER