beautypg.com

Main unit, How to handle a cd-rom, Pg. 33 – JVC Digital Video Camera GR-D24 User Manual

Page 33: Pg. 33), Heads during

background image

CAUTIONS

RE

FER

EN

CES

EN

33

MasterPage: Ref_Right

Main Unit

For safety, DO NOT…

... open the camcorder’s chassis.
... disassemble or modify the unit.
... short-circuit the terminals of the battery pack. Keep it away

from metallic objects when not in use.

... allow inflammables, water or metallic objects to enter the

unit.

... remove the battery pack or disconnect the power supply

while the power is on.

... leave the battery pack attached when the camcorder is not

in use.

Avoid using the unit…

... in places subject to excessive humidity or dust.
... in places subject to soot or steam such as near a cooking

stove.

... in places subject to excessive shock or vibration.
... near a television set.
... near appliances generating strong magnetic or electric

fields (speakers, broadcasting antennas, etc.).

... in places subject to extremely high (over 40°C) or

extremely low (under 0°C) temperatures.

DO NOT leave the unit…

... in places of over 50°C.
... in places where humidity is extremely low (below 35%) or

extremely high (above 80%).

... in direct sunlight.
... in a closed car in summer.
... near a heater.

To protect the unit, DO NOT…

... allow it to become wet.
... drop the unit or strike it against hard objects.
... subject it to shock or excessive vibration during

transportation.

... keep the lens directed at extremely bright objects for long

periods.

... expose the lens and viewfinder’s lens to direct sunlight.
... carry it by holding the LCD monitor or the viewfinder.
... swing it excessively when using the hand strap or the grip.
... swing the soft camera case excessively when the

camcorder is inside it.

Dirty heads can cause the following problems:

... No picture during playback.
... Blocks of noise appear during playback.
... During recording, the Head Clog Warning indicator “

appears.

... Recording cannot be performed properly.
In such cases, use an optional cleaning cassette. Insert it and
play back. If the cassette is used more than once
consecutively, damage to the video heads may result. After
the camcorder plays back for about 20 seconds, it stops
automatically. Also refer to the cleaning cassette’s
instructions.
If, after using the cleaning cassette, the problems still exist,
consult your nearest JVC dealer.
Mechanical moving parts used to move the video heads and
video tape tend to become dirty and worn out over time. In
order to maintain a clear picture at all times, periodic check-
ups are recommended after using the unit for about 1,000
hours. For periodic check-ups please consult your nearest
JVC dealer.

How To Handle A CD-ROM

● Take care not to soil or scratch the mirror surface (opposite

to the printed surface). Do not write anything or put a sticker
on either the front or back surface. If the CD-ROM gets
dirty, gently wipe it with a soft cloth outward from the centre
hole.

● Do not use conventional disc cleaners or cleaning spray.

● Do not bend the CD-ROM or touch its mirror surface.

● Do not store your CD-ROM in a dusty, hot or humid

environment. Keep it away from direct sunlight.

Serious malfunctioning

About moisture condensation

● You have observed that pouring a cold liquid into a glass

will cause drops of water to form on the glass’ outer
surface. This same phenomenon occurs on the head
drum of a camcorder when it is moved from a cool place
to a warm place, after heating a cold room, under
extremely humid conditions or in a place directly
subjected to the cool air from an air conditioner.

● Moisture on the head drum can cause severe damage to

the video tape, and can lead to internal damage to the
camcorder itself.

If malfunctioning occurs, stop using the unit
immediately and consult your local JVC dealer.

The camcorder is a microcomputer-controlled device.
External noise and interference (from a TV, a radio,
etc.) might prevent it from functioning properly. In such
cases, first disconnect its power supply unit (battery
pack, AC Adapter, etc.) and wait a few minutes and
then re-connect it and proceed as usual from the
beginning.

GR-D33EK.book Page 33 Thursday, October 30, 2003 9:41 PM