JVC Model KD-S580J - Manual (Page 6)

ENGLISH
6
KD-S6250/S580 [EN] GET0064-001A [J]
Remote sensor
(back side)
WARNING:
• Store the batteries in a place which children
cannot reach.
If a child accidentally swallows the battery,
consult a doctor immediately.
• Do not recharge, short, disassemble or heat the
batteries or dispose it in a fire.
Doing any of these things may cause the
batteries to give off heat, crack or start a fire.
• Do not leave the batteries with other metallic
materials.
Doing this may cause the batteries to give off
heat, crack or start a fire.
• When throwing away or saving the batteries,
wrap it in tape and insulate; otherwise, the
batteries may start to give off heat, crack or start
a fire.
• Do not poke the batteries with tweezers or
similar tools.
Doing this may cause the batteries to give off
heat, crack or start a fire.
3
Return the battery holder.
Insert again the battery holder pushing it until
you hear a clicking sound.
Preparing the remote controller
This section is ONLY FOR KD-S6250.
Before using the remote controller:
• Aim the remote controller directly at the remote
sensor on the main unit. Make sure there is no
obstacle in between.
• Do not expose the remote sensor to strong light
(direct sunlight or artificial lighting).
(back side)
1)
2)
Installing the battery
When the controllable range or effectiveness of
the remote controller decreases, replace the
battery.
1
Remove the battery holder.
1) Push out the battery holder in the direction
indicated by the arrow using a ball point
pen or a similar tool.
2) Remove the battery holder.
2
Place the battery.
Slide the battery into the holder with the +
side facing upwards so that the battery is fixed
in the holder.
Lithium coin battery
(product number:
CR2025)
EN04-06-KD-S6250/S580[J]-7 11/7/01, 7:48 PM 6