JVC MP-XP731GB - Manual (Page 96)

96
EN
• If you forget the BIOS password
The following passwords can be set on the BIOS.
• Supervisor Password
This is the password used by the administrator. If it has been set, it means that only an
individual who inputs this password correctly can set or change any of the items. The
user will be asked for this password at boot-up and BIOS setup.
• User password
When this password is set, the user is requested to enter the password to start Windows
or change a BIOS setting.
• HDD password
The password required for accessing the hard disk.
Important
• You cannot delete the BIOS password even if you forget it. To delete it forcibly, you
have to return your PC to us for chargeable service. (It may require hard disk drive
replacement.)
• To bring up the BIOS menu, turn on the PC and press the Alt and F2 keys while the
JVC logo screen is shown.
Do not change the BIOS setting unless you have adequate knowledge of computers.
A wrong setting can make your PC unable to start up again or, worse, damage it.
Q.
Setting procedure does not complete.
A.
If Internet, e-mail, or any other setting does not complete through the procedure described
in this manual, check the following.
• If the [Control Panel] display is in Classical mode, change it to the Category mode. All
the setting procedures in this manual assume the Category display mode.
TROUBLESHOOTING