JBL CREATURE SELF POWERED SATELLITE SPEAKERS AND SUBWOOFER - Manual (Page 4)

Document Number: 950-0045-001 Description: MANUAL, CREATURE, ENGLISH
Revision: A Page 4 of 6
Harman Multimedia Confidential
Using the speaker system
On/Off Switch
An on/off switch is located on the rear of the subwoofer.
There is a green LED located on bottom of each of the two satellite speakers. There is also a green LED located on the
bottom-back of the subwoofer. All three LEDs should illuminate when the system is connected correctly and receiving
power. Turn the speaker off if it will not be used for a long period.
Volume Control
The volume control can be found on the front of the control/right satellite speaker.
Touching the right + button on the front of this speaker will turn up the volume setting in increments of 2.0 dB per step. If
the button is continuously touched, after 0.5 seconds the volume level will constantly increase at a rate of 5 dB per second.
Touching the left - button on the front of the right speaker will turn down the volume setting in increments of 2.0 dB per
step. If the button is continuously touched, after 0.5 seconds the volume level will constantly decrease at a rate of 5 dB per
second until the system is muted.
The JBL CREATURE will retain the volume setting when it is turned off so that when the speaker system is turned back on,
it will restore the last volume setting.
Muting
Touching the left and right buttons simultaneously on the front of the right speaker will mute the audio. Power will remain
on (both speakers’ LED’s remain illuminated). When muted, touching either the left button or the right button, or both
buttons simultaneously will restore volume to the level prior to the activation of the mute function.
Controls on the Subwoofer
Bass - Turn the knob marked Bass clockwise to increase the subwoofer level or counterclockwise to decrease the subwoofer
level.
Treble – Turn the knob marked Treble clockwise to increase the treble level or counterclockwise to decrease the treble level.