JVC XM-EX90 - Manual (Page 40)

English
Deutsch
Français
40
XM-EX90
6 Press
0 to eject the MD.
The data in the memory is written in the MD before it is
ejected.
The display shows “UTOC writing” during MD write
operation.
• Be careful not to apply impact to the MD recorder
during writing data in the memory in the MD.
Otherwise the recording may be unplayable later.
• The data in the memory is written in the MD also
when the power is switched to the STANDBY mode
while “EDITING” is being displayed.
To correct input characters:
Characters can be corrected only before ENTER is
pressed.
1 Press 4 or ¢/> to move the cursor to the
character to be corrected.
2 Press CANCEL to erase the character.
3 Input the correct character.
To cancel all input characters:
Characters can be cleared only before ENTER is
pressed.
Press CANCEL to erase all characters then press TITLE.
To exit editing:
Press TITLE before pressing ENTER.
INPUT
CANCEL
EN26-42.XM-EX90[J]/1 98.6.4, 0:10 PM 40