GE 24922 GE Universal Remote 6 Device User Manual

Page 5

Code Identification

The Code Identification Feature allows you to
identify the 4 digit library code stored under your
device key. For example, if you want to find out what
4 digit code is stored under your TV device key,
follow the six steps below:

1. Press and hold the SETUP button until

the red indicator stays on. Release the
SETUP button.

2. Press and release the desired mode

button (TV, VCR, etc.). The red
indicator blinks, then stays lit.

3. Press and release the SETUP button.

The red indicator blinks once and
remains lit.

4. To find the first digit for

the code stored under the
mode key pressed in step
2, press each numeric
key from 0-9 in turn. The
number that causes the
indicator light to blink is
the first digit in your code.

5. To find the second digit, repeat step 4.

6. Repeat step 4 again to find the third and fourth

digits. This time the red indicator turns off and
stays off.

Code Search

If your device does not respond after you have tried
all the codes for your brand, or if your brand is not
listed, try searching for your code by following these
steps.

1. Manually turn on the device (

VCR

, etc.) to be

controlled.

2. Press and hold the SETUP button until

the red indicator stays on, then release
the SETUP button.

3. Press and quickly release the desired

mode button (TV, VCR, etc.). The red
indicator blinks off once.

4. Press the CHANNEL UP button

repeatedly (up to 300 times) until
the device to be controlled
changes channel. The red
indicator blinks off with each

5. Press and release ENTER to install the

code.

Most users will store VCR codes under the VCR button,
Cable codes under CABLE, etc. If (for example) you
want to store a VCR code under CABLE, first follow the
procedure for Direct Code Entry (page 8) and press
CABLE in step 2 of Direct Code Entry, then enter ANY
VCR code in step 3 of Direct Code Entry. Then follow
the steps above for Code Search.

Note: If the device does not have a CHANNEL UP
button, use PLAY (VCR only) or POWER instead. Code
Search starts from the currently stored three digit
number under that mode. Sometimes the first code
that “works” with your device may only allow limited
functionality (e.g. the MENU button might not work).
There may be a code that performs more functions.
Continue the code search process until the best code
is found.

button press. If you accidentally overshoot the
code required, press the CHANNEL DOWN
button to backtrack through the library until the
device changes channel. Pressing CHANNEL
UP changes direction to forward again.