JVC HX-GD7 User Manual

Page 10

To assemble and connect the AM loop antenna

To assemble the AM loop antenna

To connect the AM loop antenna cord

• If the AM loop antenna wire or speaker cords are covered with

vinyl, remove the vinyl to expose the tip of the antenna by
twisting the vinyl.

• Make sure the antenna conductors do not touch any other

terminals, connecting cords and power cord. Also, keep the
antennas away from metallic parts of the System, connecting
cords, and the AC power cord. This could cause poor
condition.

To connect the speaker cords

• When connecting the speaker cords, match the polarity of

the speaker terminals: (+) to (+) and (–) to (–).

• Use only speakers with the same speaker impedance as

indicated by the speaker terminals on the rear of the unit.

• The speakers are magnetically shielded to avoid color

distortions on TVs. However, if not installed properly, it
may cause color distortions. So, pay attention to the
following when installing the speakers.
– When placing the speakers near a TV set, turn off the

TV’s main power switch or unplug it before installing
the speakers.
Then wait at least 30 minutes before turning on the TV’s
main power switch again.

Some TVs may still be affected even though you have
followed the above. If this happens, move the speakers
away from the TV.

1 Hold

2 Insert

3 Release

• DO NOT connect more than one speaker to

each terminal.

• DO NOT push or pull the speakers as this

will damage the foot spacers at the bottom of
the speakers.

Speaker

cords

(black/blue)

Speaker cords

(black/red)

From right speaker

From left speaker