JVC HR-1080-PRO - Manual (Page 12)

MKT-0027-UMN-1.002F JVC HR-1080-PRO Video Processor User Manual
3 Installation
3.1 List of Standard Components
The JVC HR-1080-PRO processor ships with a number of standard components. When
unpacking your unit, verify that the following items are included:
• JVC HR-1080-PRO unit (qty 1)
• IEC-320 American AC power cord (qty 1)
• Infrared remote control (qty 1)
• Rack-mount adapter kit (qty 1)
• RS-232 Null Modem Cable, F-F (qty 6 ft)
• RS-232 regular cable, M-F (qty 6 ft)
• DVI cable, M-M (qty 15 ft)
• JVC HR-1080-PRO User Manual (qty 1)
3.2 Setting up your JVC HR-1080-PRO
To set up your JVC HR-1080-PRO unit, follow the steps below:
1. Connect the JVC HR-1080-PRO unit to the video input sources.
2. Connect the JVC HR-1080-PRO unit to the display device.
NOTE: If you are connecting to a panel or projector that supports the coding of HDCP
encrypted material on its DVI input, you must connect to that DVI input using JVC HR-1080-
PRO’s HDMI OUT connector (and an HDMI to DVI adapter).
3. To power up the unit, press the Power switch located on the rear of the unit, close to the
power cord. The Power switch may be left on in normal operation. The On/Setup button
on the front panel may be used to put the unit into a low-power state (Setup Mode).
NOTE: When the JVC HR-1080-PRO is in Setup (Stand-by) Mode, the output to the projector or
panel is temporarily suspended.
4. Select the output resolution to match the native resolution of the display device:
a) Place the unit in Setup (Stand-by) Mode by toggling the Operate/Setup button on the
IR remote (or by using the On/Setup button on the unit’s front panel).
b) Using the up/down arrow keys of the remote, cycle through the different setup modes
(which will be displayed on the box LCD display) until the output resolution mode is
selected (“OUT = xxx” will appear on the LCD display, where ‘xxx’ is the current
active output resolution)
c) Using the left/right arrow keys, select the desired output resolution.
Page 12
JVC Inc.