JVC HR-DD865EK - Manual (Page 14)

14
1 2 3
4 5 6
7 8 9
1
2
3
4
1
2
3
4
– –:– –
0
ACCESS VIDEO PLUS+ SCREEN
1
Press PROG.
The front display panel looks like this:
ENTER PLUSCODE NUMBER
2
Press the NUMBER keys to
enter the PlusCode
number of the programme
you wish to record, then
press OK.
● If you make a mistake,
press and input the
correct number.
The PlusCode number you enter appears on the front
display panel:
The display panel shows only a 4-digit number.
ACCESS VIDEO PLUS+ PROGRAM
SCREEN
3
The VIDEO Plus+ Program
screen appears (if you’re
just starting out, “P1”
appears).
The display panel shows the
programme start time.
Pressing
changes the
display to the programme
stop time, then the date and
preset position.
IMPORTANT
Make sure the preset position number you wish to
record is displayed; if not, see "VIDEO Plus+ Setup"
on page 56 and set the Guide Program number for
that PlusCode number correctly.
● If the number you entered is invalid, "ERROR" appears
on the screen and "Err" appears on the display panel.
Press and input a valid PlusCode number.
● If the "GUIDE PROG SET" screen appears, see
"ATTENTION – Regarding Guide Program Number
Set" on page 15.
VIDEO Plus+
Timer
Programming
Before performing VIDEO Plus+ Timer Programming:
● Make sure that the recorder's built-in clock is set
properly.
● Insert a cassette with the safety tab in place. The recorder
will come on automatically.
● Turn on the TV and select the VIDEO channel (or AV mode).
With VIDEO Plus+, timer programming is greatly simplified
because each TV programme has a corresponding code number
which your recorder is able to recognise.
BASIC OPERATIONS (cont.)
OK
2
2,6
PROG
1,6
NUMBER
5
2
PDC
7
WEEKLY
DAILY
STOP+/–
V I D E O P L U S +
[0 – 9] : VIDEO PLUS+
[+/–] : EXPRESS PROGRAMING
[PROG] : EXIT
SP
V I D E O P L U S +
1 2 3 4 5 6 7 8
[0 – 9] =
[ ] : DELETE
[PROG] : EXIT
– P1 –
VIDEO PLUS+ 123456789
START STOP
21:00 = 22:00
SP VPS/PDC OFF
DATE TV PROG
25.12 1
BBC 1
: OK
LCD panel
1
LCD PROG
ACCESS VIDEO PLUS+ DISPLAY
1
Press LCD PROG.
The LCD panel looks like this:
ENTER PLUSCODE NUMBER
2
Press the NUMBER keys to enter the PlusCode number of
a programme you wish to record, then press .
● If you make a mistake, press and input the correct
number.
The PlusCode number you enter appears on the LCD
panel:
Then go to step 3 in the right column.
You can use the remote control with LCD panel to enter the
PlusCode number.
SP/LP
4