JVC HR-A637E - Manual (Page 17)

EN
17
TIMER RECORDING
Information
On ShowView
With ShowView, timer programming is greatly simplified
because each TV programme has a corresponding code number
which your recorder is able to recognise.
NOTE:
“Guide Prog. Number” refers to the assigned TV station
numbers, according to broadcast area, for ShowView timer
recording.
IMPORTANT
Perform the following procedure after the channel setting steps
on pages 7 and 24 – 25, and after the Clock Set procedure on
page 8.
After setting the Guide Prog. Numbers, the station names and
channel positions may be incorrect if you stored or skipped
channels. In this case, re-perform Guide Prog. Number setting.
Guide Prog. Number Set
MAKE LIST OF STORED
CHANNEL POSITIONS
AND STATION NAMES
1
(Ex.)
ACCESS CH. SET DISPLAY
2
Press and hold CH SET for over 2 seconds. “AUTO”
appears on the front display panel.
ACCESS GUIDE PROG. SET
DISPLAY
3
Press PUSH JOG %fi to select “GUID”, then press OK.
The Guide Prog. Set display appears.
Channel position Station name
1 ARD
2 ZDF
3 WDR
Guide Prog.
≠
Channel Position
≠
q 6
1 2
4 5
3
6
8
0
7 9
1
3
2
OK
NUMBER
CH SET
CANCEL
PUSH JOG
TV PROG.
CONTINUED ON NEXT PAGE.