JBL 2.4G AW User Manual

Page 7

English

When connected properly, the top LED on the front of the active
speaker should be green. When first plugged in, it will sometimes
take several seconds for the Control 2.4G AW active speaker to
initialize and “wake up.” Until then, the top LED will be in red. Once
the top LED is green, the bottom LED should flash green until the
transmitter and active speaker “lock in.” It will then also light in solid
green. This LED will light in orange if the local input on the active
speaker is selected (see Page 8 under Local Input for more details).

Connection Option B

Connecting using the 3,5mm(1/8-inch) single-pin stereo jack on
your source:

Note: Make sure power is turned off on all components.

Step 1. Connect the RCA – mini-jack cable (included) to the preamp
out, line out or headphone 3,5mm (1/8-inch) output of your portable
audio player and the inputs on the transmitter module

D, as shown

in Figure 5.

Figure 5.

Step 2. Place the active speaker in the desired location in your home
near an AC outlet, as it needs to plug into the wall.

Step 3. Connect the speaker wire (included) to the push terminals on
the active speaker

5 and the push terminals on the rear of the

passive speaker

9, as shown in Figure 3. Please note that the

speaker wire supplied features a polarity stripe to help distinguish
its two conductors. Use this polarity stripe to ensure that you are
connecting the positive (+) terminal on one speaker to the positive
(+) terminal on the other, and the negative (–) to the negative (–).
It does not matter whether you use the striped conductor for
connecting the positive (+) terminals or the negative (–) terminals.

Step 4. Plug the transmitter module

B and active speaker 6 into

the wall outlet, using the correct power supply and power cord.
Make sure the transmitter’s antenna

A is extended upward.

Make sure the ID code setting on the transmitter

C is set to the

same setting as that on the active speaker

4. See Page 8 of this

manual for more information on ID codes. When connected properly,
the top LED on the front of the active speaker should be green.
When first plugged in, it will sometimes take several seconds for the
Control 2.4G AW active speaker to initialize and “wake up”. Until
then the top LED will be in red. Once the top LED is green, the bottom
LED should flash green until the transmitter and active speaker “lock
in”. It will then also light in solid green. This LED will light in orange if
the local input on the active speaker is selected (see Page 8 under
Local Input for more details).

If you are installing the speakers outdoors, please attach the
provided terminal cover to each speaker, using three M3 x 8 self-
tapping screws provided.

Portable Audio Device or

Computer Headphone Jack (3,5mm(1/8")) Mini

INPUT

CODE

1 2 3 4

0039CSK JBL On Air Control_2.4_AW_ENG_v5_GODKENDT:34199_Control_2_4G_Eng 10/06/08 15:57 Side 7