JVC ca-mxkb4 - Manual (Page 8)

5
Getting Started
Connecting the AM (MW) Antenna
Rear Panel of the Unit
• Even when connecting an outside AM (MW) antenna, keep the indoor AM (MW) loop connected.
CAUTION:
• To avoid noise, keep antennas away from the System, the connecting cord and the AC power cord.
Connecting the Speakers
Connect the right speaker to the RIGHT speaker terminals and the left speaker to the LEFT speaker terminals. “Right” / “Left” is labeled
on the rear of the speaker.
1. Open each of the terminals to connect the speaker wire leads.
2. Connect the speaker cords to the Speaker terminals of the Unit.
Connect the gray (+) and gray with black stripe (–) cords of the right side speaker to the red (+) and black (–) terminals marked RIGHT
on the System.
Connect the gray (+) and gray with black stripe (–) cords of the left side speaker to the red (+) and black (–) terminals marked LEFT on
the System.
3. Close each of the terminals.
CAUTIONS:
• A TV may display irregular colors if located near the speakers. If this happens, set the speakers away
from the TV.
• Use speakers with the correct impedance only. The correct impedance is indicated on the rear panel.
AM (MW) antenna wire (not supplied)
If reception is poor, connect the outside antenna.
AM (MW) loop antenna (Supplied)
Turn the loop until you have
the best reception.
Attach the AM (MW) loop
to its base by snapping
the tabs on the loop into
the slot in the base.
Right side (rear view) Left side (rear view)
Gray Gray
Gray with
black stripe Gray with
black stripe
MX-KB4(B).book Page 5 Tuesday, April 13, 2004 9:40 AM