JVC ca-mxkb4 - Manual (Page 17)

14
Using the CD Player
About Disc Indicator:
The Disc indicator consists of the following three kinds of indica-
tors:
One Touch Play
The power comes on, and operations are done automatically.
❏ By pressing the CD 6 button, the System will come on, and if
a CD is loaded for the disc number that was lastly selected, it
will start playing from the first track.
❏ By pressing the CD1-CD3 button, the System will come on, and
if a CD is already loaded for the selected disc number, it will
start play from the first track.
To Load CDs
1 Press the CD Open/Close
0
button on the
Unit to open the tray.
2 Place one or two CDs, with its label side up,
onto the tray.
Be sure that the CD is securely seated inside the recess on the
disc tray.
3 Press the DISC SKIP button on the Unit and
place the next CD.
When you press the button, the tray turns for the next CD.
4 Press the CD Open/Close
0
button on the
Unit.
The tray is closed.
❏ When you use an 8 cm CD, place it on the inner circle of the tray.
❏ You can load CDs while listening to the other source or while
listening to the CD being played back.
❏ When power is turned off with the tray opened, the tray is auto-
matically closed.
❏ If the CD cannot be read correctly (because it is scratched, for
example), “ NO DISC” appears on the display.
To Unload CDs
Take out the CD as shown below.
1 While the CD Player is stopped, press the CD
Open/Close
0
button on the Unit to open the
tray.
2 Remove the CD, then press the DISC SKIP
button on the Unit.
The tray turns for the next CD.
3 Repeat step 2 to remove all the CDs.
4 Press the CD Open/Close
0
button on the
Unit to close the tray.
❏ You can remove CDs while listening to the other source.
Tips:
• Removing/changing the CDs during playback
While playing back a CD (e.g. CD1), you can remove or change
the other CDs (e.g. CD2 and CD3) by pressing the CD Open/Close
0 button. After removing or changing, press the same button to
close the tray.
Changing the MP3 Playback Mode
When playing an MP3 disc, you can choose the playback mode of
the MP3 disc as follows:
TRACK mode:
The unit recognizes only tracks (files). You can play an MP3 disc
like an Audio CD.
GROUP mode:
The unit recognizes tracks (files) and albums (folders) on an MP3
disc. You can play an MP3 disc according to the way how they are
grouped.
On the remote control ONLY:
Press MP3 before or during playing an MP3 disc.
• Each time you press the button, the MP3 playback mode
changes between “GROUP” and “TRACK” alternately.
Disc Number indicator: Lights all the time.
Selected Disc indicator:Lights for the currently selected
disc number.
Disc Rotation indicator:Runs when the selected CD is
playing or paused. This indicator
goes out if a CD is not loaded for
the selected disc number.
Selected Disc
indicator
Disc Rotation
indicator
Disc Number
indicator
With the label side up
GROUP indicator appears when the MP3
playback mode is the GROUP mode.
MX-KB4(B).book Page 14 Tuesday, April 13, 2004 9:40 AM