beautypg.com

Getting started, Unpacking, Connecting am (mw) and fm antennas – JVC CA-UXG4 User Manual

Page 9: Connecting speakers

background image

6

Getting Started

Unpacking

After unpacking, check to be sure that you have all the
following items.
The number in parentheses indicates the quantity of each
piece supplied.
• FM antenna (1)
• AM (MW) loop antenna (1)
• Remote control (1)
• Batteries (2)
If any item is missing, consult your dealer immediately.

Connecting AM (MW) and FM Antennas

1

Attach the supplied FM antenna to the FM
75

COAXIAL terminal.

Fasten in up the position which gives you the best
reception, then fix it on the wall, etc.

2

Connect the supplied AM (MW) loop
antenna to the AM LOOP terminal.

Place the antenna away from the unit and adjust its
position for the best reception.

For better reception of both FM and AM (MW)

• Make sure the antenna conductors do not touch any other

terminals or connecting cords.

• Keep the antennas away from metallic parts of the unit,

connecting cords, and the AC power cord.

About the supplied FM antenna

The FM antenna supplied with this unit can be used as temporary
measure. If reception is poor, you can connect an outdoor FM antenna.

To connect an outdoor FM antenna

Before connecting the antenna, disconnect the supplied FM antenna.

Do not connect the AC power cord until all other
connections have been made.

Continued

Connecting Speakers

You can connect the speakers using the speaker cords.

1

Hold the clamp of the speaker terminal.

2

Insert the end of the speaker cord into the
terminal.

Match the polarity of the speaker terminals: red cord to
ª and black cord to ·.

3

Release your finger from the clamp.

IMPORTANT:
• Use only speakers with the same speaker impedance as

indicated by the speaker terminals on the rear of the unit.

• DO NOT connect more than one speaker to one

speaker terminal.

Red

Speaker
cord

Left speaker

Right speaker

Red

Black

Black

Speaker
cord

1

2,3

Т

В

Outdoor FM antenna
(not supplied)

Coaxial cable (not supplied)

A 75

Ω antenna with coaxial type connector

(IEC or DIN 45325) should be used.

AM

LOOP

FM 75

COAXIAL

2

1

AM

LOOP

FM 75

COAXIAL

FM antenna (supplied)

AM (MW) loop antenna (supplied)

06-07_UX-G4_UX-G3[B]3.p65

05.2.14, 8:26 PM

6