JVC CA-UXG4 - Manual (Page 23)

20
To stop recording for a moment, press REC.
Both the CD playback and tape recording are
paused. To resume recording, press TAPE
¤ ‹.
To stop recording, press 7.
The recording stops and the CD
playback is paused.
To record on both sides—Reverse Mode
On the remote control ONLY:
Press REV.MODE (reverse mode)
repeatedly until
or is lit.
• When using the Reverse Mode for Disc
Synchronized Recording, lights up and the
recording starts in the forward ( 3 ) direction first. When
the tape reaches its end, the CD playback is paused until
the tape recording changes to the reverse direction, then the
recording continues.
To cancel the Reverse Mode, press REV.MODE repeatedly
until
is lit.
When making Sleep Timer settings while Recording
Set enough time to allow for the disc to finish playing; otherwise,
the power will go off before recording is completed.
Recording Discs
—Disc Synchronized Recording
You can start disc play and recording at the same time.
On the unit ONLY:
1
Put a recordable cassette in with the exposed
part of the tape down.
• See also page 14.
2
Close the cassette holder gently.
3
Press CD ‹/8 to select the CD
player as the source.
4
Press
7 to stop the disc
playback.
• You can make a program (see page
11) if you want.
5
Press REC (recording).
REC indicator lights up on the display.
6
Press TAPE
¤ ‹.
“SYNC REC” appears and
3 indicator
lights up on the display.
CD playback and tape recording starts
automatically.
• If no cassette is inserted when you press REC
“NO TAPE” appears on the display.
• If a protected tape is inserted when you press REC
“PROTECT” appears on the display.
REC
REC
REV.MODE
REC
REC
TOTAL
CD
#/8
TAPE
DOWN
4 7 ¢
UP
DOWN
4 7 ¢
UP
19-20_UX-G4_UX-G3[B]3.p65 05.2.14, 8:27 PM 20