JVC HM-DH40000U - Manual (Page 75)

EN
75
VIDEO NAVIGATION
CORRECTIVE ACTION
Tape information cannot be shown if
it has not been recorded on this VCR.
Video Navigation cannot work
correctly on a tape if it has more than
one tape number. If this happens, fast-
forward the tape up to its end, eject it,
and try it again.
It is impossible to search the desired
program which is not recorded on
this VCR using Video Navigation.
Check the remaining memory
(
੬
pg. 52). If it is full, delete
unnecessary Video Navigation
information (
੬
pg. 51, 52).
Check the remaining memory
(
੬
pg. 52). If it is full, delete
unnecessary Video Navigation
information (
੬
pg. 51, 52).
Set “NAVIGATION” to “ON”
(
੬
pg. 43).
For details on the recording time for
Video Navigation, refer to “NOTES”
on page 42.
SYMPTOM
1. Tape information screen does not
appear for the currently inserted
tape.
2. The VCR cannot search for the
desired program.
3. “MEMORY FULL” appears on the
screen when you try to start
recording.
4. The information data for Video
Navigation is not registered.
POSSIBLE CAUSE
● The current tape inserted has not
been recorded on this VCR.
● Two (or more) tape numbers are
recorded on one tape.
● The inserted program is not
recorded on this VCR.
● The VCR’s memory for Video
Navigation is fully recorded.
● The VCR’s memory for Video
Navigation is fully recorded.
● “NAVIGATION” is set to “OFF”.
● The recording time is not enough.
CONTINUED ON NEXT PAGE \
HM-DH40000U-EN72-91 1/22/3, 5:44 PM 75