JVC VN-C2U User Manual

Page 27

The image is out of focus.

The focus can be adjusted by following the
procedure given below.

1.Set the pan and tilt positions to 0˚,0˚.

2.Remove the lens cover.

3.Loosen the screw locking the lens

block.

Note:For your safety, turn off the power

before loosening the screw.

4.Start up the VN-C2U controller so that

the VN-C2U image can be viewed.

5.Rotate the lens block slowly until the

image is in focus.

6.Securely tighten the lock screw.

7.Close the lens cover (check to make

sure that the notches on the lens cov-
er and case are aligned).

Lens block

Lens cover

Lock screw

Mount so that the notches
are aligned