JVC HD-52Z585 - Manual (Page 13)

Quick Setup Connections
Please follow the flow chart below to determine which connection setup is right for you. Then,
refer to the appropriate diagrams to connect your television to other devices that you may
have. After you are finished connecting your devices, plug the power cord into the nearest
power outlet and turn on the TV.
Step 2 – Connecting Your Devices
13
A VCR is not necessary for operation of the television. If you follow these diagrams and the
television does not work properly, contact your local cable operator.
• To connect a DVD player, see Diagram #3. A DVD player is optional.
• If you have a satellite television system, please refer to the satellite TV manual.
Diagram #2
Do you use a Cable TV Box?
Do you have a VCR? Do you have a VCR?
Diagram #1 Diagram #3 Diagram #1
Yes No
Yes No Yes No
Basic Operation
Turn the television on and off by pressing the P OWER button at the top right corner
of the remote. The POWER LED will light blue. If this is the first time you are
turning on the TV, the interactive plug-in menu appears.
• Make sure the TV/CATV switch is set to TV. Move the switch to CATV only if
you need to operate a cable box.
• Slide the VCR/DVD selector switch to VCR to control a VCR. Slide to
DVD to control a DVD player. Please see pages 25 to 28 for instructions on
programming your remote control to operate a cable box, VCR or DVD player.
POWER
T
VCR DVD
A
TV CATV
Note:
• If the lamp replacement message appears when you turn the television ON, see page 68.
HD-ILA Eng "C" 13 10/25/04, 12:11:43 PM