JVC HR-DD750U - Manual (Page 42)

42
EN
TIMER RECORDING (cont.)
You can directly program the VCR’s timer to record up to 8
shows, as far as a year in advance. Remember, the clock must be
set before you can program the timer (
੬
pg. 8 or 11).
Express Timer
Programming
Turn on the TV and select the VCR channel 3 or 4 (or AV
mode).
1 2 3
4 5 6
7 8 9
0
2
4
1
3
PROG.
START+/–
STOP+/–
DATE+/–
LOAD A CASSETTE
1
Make sure the record safety tab is intact. If not, cover
the hole with adhesive tape, then load it into the VCR.
● The VCR comes on, and the counter is reset,
automatically.
ACCESS VCR PLUS+
SCREEN
2
Press PROG.
ACCESS PROGRAM
SCREEN
3
Press START +/–. (If you’re
just starting out,
“PROGRAM 1” appears.)
SET PROGRAM START TIME
4
Press START +/– to enter
the time you want
recording to start.
● Press and hold START
+/– to move in 30-
minute increments, or
press and release
repeatedly to move 1
minute at a time.
SET PROGRAM STOP TIME
5
Press STOP +/– to enter the time you want recording to
stop.
● Press and hold STOP +/– to move in 30-minute
increments, or press and release repeatedly to move 1
minute at a time.
SET PROGRAM DATE
6
Press DATE +/–. (The current date is displayed on
screen. The date you enter appears in its place.)
SET CHANNEL NUMBER
7
Press CH +/–.
● If you are using a DBS receiver, see "ATTENTION
FOR DBS RECEIVER USERS" on next page.
● Holding down CH +/– rapidly scans through the
channels.
PROGRAM 1
START STOP
8:00 AM = – –:– –AM
DATE CH
– –/– –/– – – – – SP
PRESS (+/–, SP/EP, 8=DAILY,
9=WEEKLY), THEN (0K)
PRESS (PROG.) TO END
PROGRAM 1
START STOP
– –:– –AM = – –:– –AM
DATE CH
– –/– –/– – – – – SP
PRESS (+/–, SP/EP, 8=DAILY,
9=WEEKLY), THEN (0K)
PRESS (PROG.) TO END
CH+/–