JVC UX-V9RMD - Manual (Page 33)

29
Engli
s
h
■ ■
Troubleshooting
• If you are having a problem with your System, check this list for a possible solution before calling for service.
• If you cannot solve the problem from the hints given here, or the System has been physically damaged, call a qualified person, such as
your dealer, for service.
Symptom Possible Cause Action
No sound is heard. • Connections are incorrect, or loose.
• Headphones are connected.
• Check all connections and make correc-
tions. (See pages 3- 5.)
• Disconnect the headphones.
Poor radio reception • The antenna is disconnected.
• The AM Loop Antenna is too close to the
System.
• The FM Wire Antenna is not properly
extended and positioned.
• Reconnect the antenna securely.
• Change the position and direction of the
AM Loop Antenna.
• Extend FM Wire Antenna to the best
reception position.
The CD skips. The CD is dirty or scratched. Clean or replace the CD.
The CD does not play. The CD is upside down. Put the CD in with the label side up.
The MD cannot be inserted. An MD has already been inserted. Press the MD 0 button to eject the inserted
MD and insert a new MD.
Recording cannot be made on MD. The accidental erasure prevention knob of the
MD is set to the open position. Set it to the close position.
Timer fails to start. Present time is not correct. Set the time correctly.
Unable to operate the Remote Control. • The path between the Remote Control and
the sensor on the Unit is blocked.
• The batteries have lost their charge.
• Remove the obstruction.
• Replace the batteries.
Operations are disabled. The built-in microprocessor has malfunc-
tioned due to external electrical interference. Unplug the System then plug it back in.