Connections – JVC CS-BB2 User Manual

Page 2

When using LINE IN jacks

NOTES:
• The volume of this unit is set to the maximum when remote controller is not connected.
• If your receiver is equipped with the DSP (Digital Signal Processor), connect this unit to the Front Line Output jacks of the receiver.
• When connecting to the Line Output jacks, make sure that the output level of the receiver is 2 V or lower; otherwise, sounds will be distorted.

• Ground wire connection

• Do not connect the power lead to any other sources than the battery.

CONNECTIONS

Cautions

Ground wire

Firmly attach the ground wire to the metallic body or
to the chassis of the car—to the place uncoated with
paint (if coated with paint, remove the paint before
attaching the wire). Failure to do so may cause
damage to the unit.

• Do not cut off the fuse; otherwise, it may be short-circuited, and cause a fi re.

• Do not connect the blue with white stripes to any other wire than the remote out (DC
12

V) and ACC power.

After connection, reconnect the battery negative terminal and make sure stop lamps
and others can operate normally.

The fuse is cut off.

Fuse

When using speaker input terminal

NOTES:
• The volume of this unit is set to the maximum when the remote controller is not connected.
• If your receiver is equipped with the DSP (Digital Signal Processor), connect this unit to the front speaker output of the receiver.

CS-BB2[J/U].indd 2

1/23/06 4:56:38 PM