Initial setup, Set lock code – JVC HD-P70R1U User Manual

Page 49

Channel guard and V-Chip settings are protected by a four-digit lock code. Your TV comes
preset with a lock code of “0000”. You may change the code to any four-digit number you wish.
To change the lock code, follow the steps below.

Press the M

ENU

button

π†

To SET LOCK CODE

√®

To operate (lock icon appears)

Press Z

ERO

to access the lock code

The first digit will be highlighted

√®

To select the number

π†

To move to the next digit

Continue to follow these directions for all four numbers

Press the OK button to finish (your lock code is now set)

Press the Menu button when finished

• After a power interruption you must reset the lock code.

• Write your lock code number down and keep it hidden from potential viewers.

• If you forget the lock code, a new code may be set using the steps listed above.

Notes:

When a viewer attempts to watch a blocked channel, this message appears:

The channel will remain blocked until the correct lock code is entered (see above for
information on setting your lock code).

Initial Setup

Set Lock Code

LOCK CODE

SET LOCK CODE

SELECT

OPERATE

EXIT

PRESS TO FINISH

0000

THIS PROGRAMMING EXCEEDS
YOUR RATING LIMITS.
PLEASE ENTER LOCK CODE BY
10 KEY PAD TO UNLOCK IT.
NO. - - - -

LCT2024 English.indd 49

12/13/05 11:44:30 AM