JVC PC-X290 - Manual (Page 43)

– 16 –
English
You can play back only type I (Normal) tapes.
Playing Back a Tape
1
Press STOP/EJECT
7 /0 for the deck you
want to use.
2
Put a cassette in, with the exposed part of the
tape down.
3
Close the cassette holder gently.
4
Press TAPE.
5
Press PLAY 3.
The tape play starts.
When the tape plays to the end, the deck
automatically stops.
To stop during play, press STOP/EJECT 7/0.
To operate the other deck, press STOP/EJECT 7/0, then
PLAY
3 on the other deck.
To fast wind to the left or to the right, press REW
1/
FF ¡ while the tape is not running.
To remove the cassette, press STOP/EJECT
7/0.
To play the tapes in the decks B and A continuously
1
Set the cassette tapes in the decks A and B.
• If the tape direction is set wrong, replace the cassette.
2
Press PLAY
3 for the deck B.
The tape in the deck B begins to play.
3
Press PAUSE 8, then press PLAY 3 for the
deck A.
When the tape in the deck B ends, the tape in the deck A
automatically begins to play.
The use of the C-120 or thinner tape is not
recommended, since characteristic deterioration
may occur and this tape easily jams in the pinch-
rollers and the capstans.
TAPE
Playing Back Tapes
PAUSE
For Deck A
For Deck B
EN13-16_PC-X290[C]_f.p65 04.3.10, 1:35 PM 16