JVC BD-X200U - Manual (Page 48)

87
This product uses partial third-party software.
For information concerning the software used, login via FTP by
inputting the following into the unit and view the readme.txt file:
User: anonymous
Password: None
(If the IP address of the unit is set to 192.168.0.2, FTP
connection can be established by entering ftp://196.168.0.2 in
the address bar of Internet Explorer.)
English
About the audio mode during DV input
When inputting Audio UNLOCK mode signals from the DV input, high harmonic signals modulated from the
audio source may be recorded as noise in rare cases. If this occurs, set the audio mode of the input source to
LOCK mode, or use the LINE input or YC input.
This unit can detect audio signals of UNLOCK mode during DV input. When UNLOCK mode is detected, the
unit displays:
“DV A UNLOCK” on the unit LCD
“UNLOCKED AUDIO(DV)” on the screen
until recording is started.
(May also be displayed when playing back a blank tape.)
In order to achieve higher quality recording, setting the source of DV input to the LOCK mode is recommended.
* About audio LOCK/UNLOCK mode
For DV digital signals, synchronous relationship of video and audio signals is referred to as LOCK mode, and
asynchronous relationship of video and audio signals is referred to as UNLOCK mode.
In the case of DV, 44.1kHz mode is normally the UNLOCK mode.
For the 48 kHz and 32 kHz modes, settings differ depending on the inputting video device. Please check
instruction manual of the used.
E
LLT0056-001A
(BD-X200E)