JVC CA-DXT7 - Manual (Page 69)

10
English
Listening to the Radio
To select the AM tuner interval spacing
Some countries space AM stations 9 kHz apart, and other
countries use 10 kHz spacing.
1
Select “AM,” then turn off (stand by) the System.
2 Select the AM tuner interval spacing.
To select the band (FM/AM)
To tune in to a station
While FM or AM is selected...
Frequency starts changing on the display.
When a station (frequency) with sufficient signal strength is
tuned in, the frequency search stops.
• When you repeatedly press the button, the frequency
changes step by step.
To stop searching manually, press either button.
If the received FM station is hard to listen
To preset stations
You can preset 30 FM and 15 AM stations.
• To cancel the operation during procedure, press CANCEL.
1
Tune in to a station you want to preset.
• You can also store the monaural reception mode for FM
preset stations if selected.
2 Start presetting.
3 Select a preset number.
4 Store the station.
To tune in to a preset station
1 Select the band (FM or AM).
To select 9 kHz:
To select 10 kHz:
INFO
Main Unit
ONLY
FM AM
(holding then...)
(holding then...)
FM/AM FM AM
1 sec.
Increases the frequencies.
Decreases the frequencies.
The MONO indicator lights on the
display. Reception will improve though
stereo effect is lost—monaural reception
mode.
To restore the stereo effect, press the
button again (the MONO indicator goes
off).
Examples:
To select preset number 5, press 5.
To select preset number 15, press +10,
then 5.
To select preset number 30, press +10,
+10, then 10.
• You can also use +/– buttons.
Remote
ONLY
FM MODE
Remote
ONLY
SET
1 2 3
4 5 6
7 8 9
10 0 +10
SET
FM/AM FM AM
DX-T7_T9[UGUX]-f.book Page 10 Wednesday, February 16, 2005 1:10 PM