JVC CA-DXT7 - Manual (Page 170)

5
English @
Front main speakers and matrix surround
speakers
• When connecting the speaker cords, match their polarity
with that of the speaker terminals: red/white to (+) and black
to (–).
• Use only speakers with the same speaker impedance as
indicated by the speaker terminals on the rear of the System.
• The front main speakers are magnetically shielded to avoid
color distortions on TVs. However, if not installed properly,
it may cause color distortions. So, pay attention to the
following when installing the speakers.
– When placing the speakers near a TV set, turn off the
TV’s main power switch or unplug it before installing the
speakers.
Then wait at least 30 minutes before turning on the TV’s
main power switch again.
Some TVs may still be affected even though you have
followed the above instruction. If this happens, move the
speakers away from the TV.
¤
Powered subwoofer
#
To adjust the voltage selector
Preparing the remote control
• Dispose of batteries in the proper manner, according to
federal, state, and local regulations.
• DO NOT connect more than one speaker to
each terminal.
• DO NOT push or pull the speakers as this
will damage the foot spacers at the bottom
of the speakers.
1 2
3 4
From right front main
speaker
From left front
main speaker
From left matrix
surround speaker From right matrix
surround speaker
To remove the speaker grilles of the main speakers
Use a screwdriver to rotate the
voltage selector so that the voltage
mark is pointing at the same voltage
as where you are plugging in the unit.
(See also the back cover page.)
DO NOT plug in before setting the voltage
selector and all connection procedures are
complete.
When using the remote
control,
point the top of the
remote control toward the
remote sensor as directly as
possible. If you operate it
from a diagonal position,
the operating range (approx.
5 m) may be shorter.
DO NOT recharge, short, disassemble or
heat the battery or dispose of it in a fire.
Holes
Speaker grille
Projection
From the powered subwoofer
(not supplied)
Voltage mark
R6(SUM-3)/AA(15F)
DX-T5[UGUX].book Page 5 Tuesday, February 1, 2005 3:45 PM