JBL ESC550 - Manual (Page 7)

– 7 –
For satellites, thread speaker
wire through the hole in the
bottom of the speaker, then
feed it through the recessed
wire channel. Separate and strip the ends of
the speaker wire as shown.
Speakers and electronics ter-
minals have corresponding “+”
and “–” terminals. It is impor-
tant to connect both speakers
identically: “+” on the speaker to “+” on the amplifier and
“–” on the speaker to “–” on
the amplifier. Wiring “out of
phase” results in thin sound,
weak bass and a poor stereo
image.
Speaker Connection Tips
Front
Speakers
+ –
+ –
Surround
Speakers
AC
120V
˜ 60Hz
575W
MAIN
POWER
POWER
INPUT
SUBWOOFER
LEVEL
FUSE
ON
OFF
CAUTION:
FOR CONTINUED PROTECTION
AGAINST RISK OF FIRE
REPLACE WITH SAME
TYPE T 8A/250V FUSE.
ATTENTION:
UTILISER UN FUSIBLE DE
RECHANGE DE MEME
TYPE T 8A/250V.
CAUTION:
DISCONNECT SUPPLY CORD
BEFORE CHANGING FUSE.
ATTENTION:
DEBRANCHER AVANT DE
REMPLACER LE FUSIBLE.
The speaker cables are clearly
labeled for proper hook up to
the corresponding speaker.
Connect the “+” portion of the cable to the red terminal on
the speaker and the “–”
portion of the cable to the
black terminal on the speaker.
Remote Control Battery Installation
+
+
+
Push small tab towards
battery slot and pull battery
drawer out. Remove old battery. Insert new battery with “+”
side up, and slide battery
drawer back into remote.
ESC550 Simply Cinema OM 7/22/98 4:34 PM Page 7