John Lewis JLDW 1221 - Manual (Page 28)

Removing the appliance worktop
1. Remove the appliance worktop by
unscrewing the two rear retaining
screws (1)
2. Pull the worktop from the back of the
appliance (2).
3. Lift the worktop (3) and slide it out of
the front slots.
Insert the appliance once the levelling has
been done.
When inserting the appliance, ensure that
the water inlet and drain hoses are not
kinked or squashed.
During all operations that involve
accessibility to internal components the
appliance must be unplugged.
Be sure that once the appliance has been
installed, it is easily accessible for the service
engineer in the event that a repair is
required.
If the appliance is later used as a freestanding
appliance, the original worktop must be
reassembled.
The plinth on freestanding appliances is not
adjustable.
Caution! It is necessary to protect
the underside of the kitchen worktop
from condensation. A plastic top
cover can be purchased, contact your
local John Lewis branch.
Levelling of the appliance
Good levelling is essential for correct closure
and sealing of the appliance door.
When the appliance is correctly levelled, the
door will not catch on either side of the
cabinet.
If the appliance door does not close
correctly, loosen or tighten the adjustable
feet until the level of the appliance is perfect.
28