Jacuzzi F258000 User Manual

Page 16

FIXED PANEL ASSEMBLE TO BATH

11. Screw 1 1/2" Allen set screw 3/4" deep into the bottom of the fixed panel. Lay a 1/4" bead of sealant under

the bottom rail and inside the back channel of the vertical frame. Place the assembly against the vertical
edge of the tower and onto the bath surface, interlocking the two extrusions. (See Illustration 15.) Secure the
assembly to the bathtub using one (1) nut and washer and four (4) screws and washers following the fasten-
ing sequence. Gently push on the shaded portion of the bottom rail (see Illustration 15) to align with the holes
in the bath shell. After installing the fixed panel, apply sealant along all four inside edges of the glass frame.
Clean up excess sealant.

VERTICAL
EDGE OF
TOWER

FASTENING
SEQUENCE

ILLUSTRATION 15

HEX LOCKNUT
#8-32

NUT

QTY.-1

M4.2X19MM
STAINLESS STEEL

SCREW

QTY.-4

FLAT WASHER
#8 TYPE B
STAINLESS STEEL

WASHER

QTY.-5

SET SCREW
#8-32 x 1 1/2"

SCREW

QTY.-1

(5)

(4) R

CAULK

LOCATED IN HARDWARE KIT

GENTLY PUSH

THIS AREA