How to attach the lens cap, How to attach the shoulder strap, Power – JVC GR-D350U User Manual
Page 11: Charging the battery pack, Pg. 11), Dc input connector [dc] (੬ pg. 11), Wer/charge lamp (੬ pg. 11, 17), Elet (੬ pg. 11), Pg. 11 f, Lens cap
EN
11
GETTING STARTED
MasterPage: Start_Right
GETTING ST
AR
TED
How To Attach The Lens Cap
To protect the lens, attach
the provided lens cap to the
camcorder as shown in the
illustration.
NOTE:
To confirm the lens cap is on
correctly make sure the cap is
flush to the camcorder.
How To Attach The Shoulder Strap
Follow the illustration.
1
Thread the strap through the eyelet.
2
Fold it back and thread it through the strap
guide and the buckle.
● To adjust the length of the strap, loosen and then
tighten the strap in the buckle.
3
Slide the strap guide fully towards the eyelet.
This camcorder’s 2-way power supply system
lets you choose the most appropriate source of
power. Do not use provided power supply units
with other equipment.
Charging The Battery Pack
1
Set the Power Switch to “OFF”.
2
With the arrow on the battery pack pointing
downward, push the battery pack slightly against
the battery pack mount
1.
3
Slide down the battery pack until it locks in
place
2.
4
Connect the AC Adapter to the camcorder.
5
Plug the AC Adapter into an AC outlet. The
POWER/CHARGE lamp on the camcorder
blinks to indicate charging has started.
6
When the POWER/CHARGE lamp goes out,
charging is finished. Unplug the AC Adapter
from the AC outlet. Disconnect the AC Adapter
from the camcorder.
Place here during
shooting.
3
2
2
1
Strap guide
Buckle
Eyelet
Power
1
2
Battery pack
PUSH
BATT.
Power
switch
Arrow
Battery pack mount
To AC outlet
AC Adapter
POWER/
CHARGE
lamp
To DC connector
GR-D350US.book Page 11 Tuesday, June 20, 2006 4:58 PM