Jet Tools OES-80CS - Manual (Page 7)

7
Unpacking
Upon delivery, open shipping containers and check
that all parts are in good condition. Any damage
should be reported to your distributor and shipping
agent immediately. Before proceeding further, read
your manual and familiarize yourself thoroughly
with assembly, maintenance and safety
procedures.
Compare the contents of your container with the
following parts list to make sure all parts are intact.
Missing parts, if any, should be reported to your
distributor. Read the instruction manual thoroughly
for assembly, maintenance and safety instructions.
Shipping Contents
0 1 Front Panel with Door (Stand)
0 1 Rear Panel (Stand)
0 2 Side Panel (Stand)
0 1 Shelf
0 2 M5x10 Screw
0 2 M5 Flat Washer
0 2 M5 Lock Washer
0 1 Extension Table Assembly
0 1 Drum Guard & Dust Port
0 1 Owner’s Manual
0 1 Warranty Card
0 1 Table and Motor Unit
0 1 Back Stop Bracket
0 1 Belt Tension Handle
0 1 Belt Tracking Tool
0 1 Miter Gauge Assembly
0 1 Sanding Belt
Cabinet Hardware
0 1 Lock Knob (20mm Length)
0 2 Lock Knob (12mm Length)
0 1 Lock Knob (35mm Length)
0 4 Cabinet Pads
0 4 5/16” x 5/8” Screws
22 5/16” Flat Washers
12 5/16” Hex Nuts
0 8 5/16” x 5/8” Hex Cap Bolts
0 2 5/16” x 1-1/4” Hex Cap Bolts
0 4 Larger O/D 5/16” Flat Washers
10 5/16” Lock Washers
Extension Table Hardware
0 5 1/4" x 5/8” Hex Cap Bolts
0 5 1/4" Flat Washers
0 5 1/4” Lock Washers
0 1 Bracket
0 2 10-24x3/4 Socket Head Cap Screws
Dust Chute Hardware
0 3 Pan Head Screws
Tools Needed for Assembly
2 12mm Wrench or sockets
1 10mm Wrench or sockets
1 Flat Head Screw Driver
1 Cross Point Screw Driver