Jet Tools OES-80CS User Manual

Page 16

Text mode
Original mode

Contour Sanding

Referring to Figure 19:

Contour sanding is done from the extension table
mounted on the motor where the sanding belt
wraps around the drive drum (D). To set up the
sander for contour sanding:

1. Loosen the two lock knobs (C) that secure the

drum guard & dust port (E).

2. Swing the end guard (E) back, bringing the

drive drum (D) into view.

3. Tighten

the

lock knobs (C).

4. Mount

the

extension table (A) to the sander by

inserting the post (B) into the bracket (F).

5. Set the table to the desired height, then secure

into position by tightening the lock knob (G).

Important: When the extension table (B) is not in
use, the drum guard & dust port (E) should always
be in the closed position so the drive drum (D) is
not in view.

Figure 19