JVC AV 32P903 - Manual (Page 18)

Connections
1) Plug one end of the AV Compu Link Cable into the AV Compu Link Input on your VCR,
DVD, or other Compu Link device.
2) Plug the other end of the AV Compu Link Cable into the AV Compu Link Input at the rear of
the TV.
NOTE:
• In order for the VCR playback to begin automatically, the recording tabs must be remove from
the VHS tape. If the tab is in place, automatic switching will occur when you push the VCR’s
Play button.
• The AV Compu Link cable has a male 3.5 mm (mono) plug on each end.
• If your JVC-brand VCR has “A Code/B Code Remote Control Switching” (see your VCR’s
instruction book), using VCR A Code will switch the TV to Input 1.
• To connect a JVC HiFi receiver or amplifier for a completely automated home theater, see
the HiFi’s connection instructions for detailed connection information.
• AV COMPU LINK III is compatible with any AV Compu Link III receiver.
Connecting to JVC AV Compu Link III
JVC’s AV Compu Link feature makes playing video tapes or DVDs totally automatic. Simply
insert a pre-recorded tape into your JVC-brand VCR or DVD into your JVC DVD Player and
the device will automatically turn on and begin playback. At the same time, using the AV
Compu Link, the VCR or DVD player sends a signal to the television telling it to turn on and
switch to the proper video input.
• The AV Compu Link cable may be included with the JVC AV Compu Link accessory you
wish to connect. If it is not, contact an authorized JVC Service Center for
part # EWP 805-012.
• AV Compu Link can only be used with JVC-brand products.
18
AV-36/32P903 English 6/18/02 9:23 AM Page 18