Jensen KT2056 User Manual

Page 9

LISTENING TO THE RADIO

1. Set the BAND selector to the desired band, AM or FM.
2. Set the VOLUME control to a low setting.
3. Slide the ALARM switch to the ON position.
4. Select your desired station with the TUNING control.
5. Adjust the VOLUME control to a desired setting.
6. When you finished listening, slide the ALARM selector to the OFF position to
turn the radio 'Off'.

ANTENNA INFORMATION

AM - The AM bar antenna is inside the cabinet. If the AM reception is weak, change
the position of the cabinet until the internal antenna picks up the strongest
signal

FM - The FM antenna is built-in to the AC power cord. If the FM reception is weak
try varying the position and direction of the power cord until you find the
strongest signal.

WAKE TO RADIO

1. Slide the ALARM selector to the ON position and select the band, station, and
volume level that you wish to hear when the alarm comes 'On', then slide the
ALARM selector to the AUTO position and the ALM indicator will light up.
2. Reconfirm the wake up time settings by pressing the ALARM button.
3. The radio will turn 'On' at the selected wake up time. It will play for about two
hours and then shut off automatically.
4. To stop the radio sooner, press the ALARM button. The radio will stop but
the alarm remains set and will turn the radio on again at the same time on the
following day.
5. If you do not want the alarm to turn the radio on on the following day, set the
ALARM selector to the 'OFF' position.