Jensen Smart Talk JCR-290 - Manual (Page 17)

You can turn the alarm off for the day only so that it will sound again on
the following day or you can turn the alarm completely off by disabling it.
MANUAL OPERATION
1. When an alarm is sounding, press the ON/OFF button (#12) to turn
the alarm off only for the day. The alarm will sound again the next
day at the same preset time. The alarm indicators on the display
(#25 & #26) will remain on.
2. If you do not wish the alarm to sound again, you can disable it by
pressing either the AL1 ON/OFF BUTTON (#2) or AL2 ON/OFF
BUTTON (#8). The corresponding alarm indicators on the display
(#25 & #26) will go off.
3. To enable the alarms again, press either the AL1 ON/OFF BUTTON
(#2) or AL2 ON/OFF BUTTON (#8). The corresponding alarm
indicators on the display (#25 & #26) will turn on.
TURNING OFF THE ALARM
E-16
2. Say “Snooze” during one of the pauses in the alarm sound to
activate the 9-minute snooze.
3. If your command is correctly recognized, the SNOOZE INDICATOR
(#28) will turn on.
4. When snooze expires, the alarm sound will resume.
5. You can repeat snooze operation for a maximum of 6 times within
60 minutes from the original preset alarm time.
6. You can cancel snooze any time by saying “Alarm Off” or manually
pressing ON/OFF BUTTON (#12).
7. If you press the SLEEP BUTTON (#10) once, snooze and only the
alarm in effect will be cancelled at once and go into sleep mode
directly. The desired sleep time can be adjusted by pressing the
SLEEP BUTTON (#10) repeatedly.
8. If the “Alarm Off” command is correctly recognized, the unit will
reply “Yes” and SNOOZE INDICATOR (#28) will go off.
9. The alarm will now be off and ready to sound the next day at the
preset time.