Jensen Smart Talk JCR-290 - Manual (Page 12)

TO SET THE CURRENT TIME
1. Start by saying the trigger word “Smart Talk” or press the SNOOZE
BAR (#11).
2. The unit will reply “Yes” and will wait for your next command.
3. Say “Set Time” and the unit will reply “Tell me the current time
including AM or PM”.
4. Say the current time you wish to set the clock to. Example: to set
the clock to 3:23AM, say “Three Twenty Three AM”.
5. When the time is successfully understood, the unit will reply, “The
time is …” and repeat the time you gave. Example: if you said to
set the time to 3:23AM, the reply will be “The time is three-twenty-
three AM”.
6. If the unit fails to understand the time given, it will reply, “I’m sorry.
I didn’t get that. Please tell me the current time, for example,
seven-thirty-five PM”. Now repeat step #4 above.
7. If the unit fails to understand the time given a second time, it will
reply, “I’m sorry. I did not understand you, please start over or
set the time manually”. If this occurs, repeat steps #1 - 4 above
again making sure you speak clearly in a normal voice and avoid
pauses between words.
TO CHECK THE CURRENT TIME
1. Start by saying the trigger word “Smart Talk” or press the
SNOOZE BAR (#11).
2. The unit will reply “Yes” and will wait for your next command.
3. Say “Time” and the unit will reply “The time is ...” followed by the
present time.
CURRENT TIME SETTING AND REPORTING
TO SET THE ALARM TIME (AL1/AL2)
1. Start by saying the trigger word “Smart Talk” or press the
SNOOZE BAR (#11).
2. The unit will reply “Yes” and will wait for your next command.
ALARM TIME AND ALARM SOUND SETTING /
CHECKING
E-11