Jensen Smart Talk JCR-290 - Manual (Page 13)

E-12
3. Say “Set Alarm” and the unit will reply “Say Alarm One or Alarm
Two”.
4. To set Alarm One, say “Alarm One”. You can also say the
command “Cancel” during this step if you wish to cancel setting
the alarm and the unit will reply “OK” to confirm..
5. If the unit fails to understand the alarm source given, it will reply,
“Please Repeat”. Now repeat step #4 above.
6. If the unit fails to understand the alarm source given a second time,
it will reply “I’m sorry. I did not understand you, please start
over or set the alarm time manually”. If this occurs, repeat steps
#1 - 4 above again making sure you speak clearly in a normal voice.
7. When the alarm source is successfully understood, the unit will reply,
“Please say the time you would like the alarm to sound,
including AM or PM”.
8. Say the time you wish Alarm One to sound. Example: to set Alarm
One to 10:19AM, say “Ten- Nineteen AM”.
9. When the alarm one time is successfully understood, the unit will
reply “Alarm One is now set to …” and repeat the time you gave.
Example: if you said to set the alarm time to 10:19AM, the reply will
be “Alarm One is now set to ten-nineteen AM”. The Alarm One
indicator on the display (#25) will now light.
10. If the unit fails to understand the alarm time given, it will reply, “I’m
sorry, I didn’t get that. Please tell me the time you would like
the alarm to set, for example, eight-thirty AM”. Now repeat step
#8 above.
11. If the unit fails to understand the alarm time given a second time, it
will reply “I’m sorry. I did not understand you, please start over
or set the alarm time manually”. If this occurs, repeat steps #1
– 4 and 8 above again making sure you speak clearly in a normal
voice and avoid pauses between words.
12. To set Alarm Two, repeat steps #1 - 4 above and say “Alarm
Two” when prompted (step #4). The Alarm Two indicator on the
display (#26) will light once complete.