Jet Tools JWBS-18X-3 - Manual (Page 9)

9
Unpacking
Contents of Shipping Container
1 Band Saw
1 Table
1 Fence and Rail Assembly
1 Resaw Guide and Knob
1 Miter
Gauge
1 Owner’s Manual
1 Warranty Card
1 Accessory Package Contains:
Hardware Bag
2 Knobs
1 Handle
1 10/12mm Wrench
Fence Hardware Bag
4 Hex Cap Screws
4 Flat Washers
4 Lock Washers
Rail Hardware Bag
9 Hex Cap Screws
9 Flat Washers
9 Lock Washers
1. Remove the crate and packing material from
the band saw except for the transport skid on
the bottom.
2. Move the saw to its permanent working
location. The site should be dry, well lit, and
have enough room to handle long stock and
the service and/or adjustment of the machine
from any side.
3. Move the band saw off the skid.
4. Clean all rust protected surfaces with a mild
solvent or diesel fuel and a soft cloth. Do not
use lacquer thinner, paint thinner, or gasoline.
These will damage painted surfaces.
Tools Included for Assembly
1. 10/12mm Open End Wrench
Tools Required for Assembly & Adjustments
2. 14mm Open End Wrench
1. Cross Point Screw Driver
1. Combination
Square